Harley Davidson Exhaust Bolt Size

Here are the parts you need to replace those old rusted exhaust studs and nuts on your Harley Davidson engine.

Harley davidson exhaust bolt size. With the bracket removed and clamp loosened remove the crossover pipe using a twisting motion. Its part number 35 in this bike bandit schematic. Supertrapp Stainless Steel Bolt Kit for 4 in.

097-109 mm Spark plug torque - 12-18 ft-lbs 16-24 Nm Oiling System. Vance. Do you mean the nuts because the exhaust are connected via studs not bolts and if those came out.

STEEL BAFFLE SET V-SLOTS 2 OD 4 LONG PAIR. Ive never seen any just loosen up and fall off other than those that were not properly installed. Used on 1966-1984 Shovelhead.

Remove the support bracket using a 12 wrench before sliding the bracket off of the pipe. The nuts have a 38 12 point hex head. Longer length inserts are available on our Inch page click here for inch page.

If you are serious about making horsepower on the street with your Harley-Davidson drag pipes will not fit into your engine program plans. Discard clamp from Step 2. The bike bandit part number is 467658 1678478-001 but it doesnt tell me the size of the nut ex.

The following Tables list some of the most common. Calling it an AF would be a term used in the UK to mean it is not metric or whitworth as the tools are measured across the flats of the bolt heads hence the terminology AF as whitworth are tools are marked with the thread size metric came along later and. Position the sliding bracket so the rubber mount H is at the center of the sliding bracket.